Following the sequence pattern shown in the appropriate service manual, tighten the camshaft bearing cap bolts to 89 in-lbs.
We use cookies to give you the best possible experience on our website. 10° angle.
Camshaft Sprocket Bolt 75 Connecting Rod Cap Nut 33 Cradle to Body Bolts 151 Crankshaft Sprocket Bolt 158 Cylinder Head Bolt DOHC Tighten all bolts in sequence to 22ft/lbs.
In addition, verify that the camshaft lobe (1) is centered over the cam follower roller.
Or where can I fond them. (d) Apply seal packing to the camshaft housing plug. What are the Torque specs for the camshaft bolts on the 2.4L engine?
Then tighten all bolts to 37ft/lbs. Make sure all the arrows point the same direction! Repeat sequence, tightening all bolts an additional 1/4 turn. 2005 Ford Expedition 5.4. How-To: Replace the Valve/Camshaft Cover (1.4L Turbo) Overview The valve cover of the 1.4L Turbo engine houses the PCV system.
Install cap 4. Whether due to a leak in the gasket or a failure in the PCV system, this valve cover may need to be replaced. What are the camshaft bearing cap tightening sequence and torque values on a 2003 infiniti g35 sedan auto transmission, - Answered by a verified Nissan Mechanic. (b) Align the timing marks (1-dot mark) of the camshaft drive and driven main gears, and place the 2 camshafts. Note: If any of the rocker arms are not installed properly, loosen the camshaft bearing caps and reposition the rocker arms. I have been replacing the timing belt for a family member and he is on a budget already and doesn't want to buy the book, we just need the cam gear bolt torque specs or master engine torque specs. ... camshaft retainer plate bolt = 106 in.
• …
(c) Set the timing marks (1-dot mark) of the camshaft drive and driven main gears at approx.
The ca … read more
Step 1) tighten to 44 ftlbs.
Over 6,000 Automotive Torque Specs. Install caps 1 and 7. Search Car Torque Specifications by Engine or Model Ford 5.4L-330ci-V8 Engine Torque Specs.
It … Cylinder head bolts. I had to have the camshaft, all the lifters, and 2 valves replaced. Can you give me the torque specifications and tightening sequence for the right side cylinder head. **Torque specs for caps is 15 ft lbs** Install caps 2 and 6, gradually tighten untiil cam is drawn down fully and evenly in the bearing saddles.
SOHC Tighten all bolts in sequence to 22ft/lbs. Heres the diagram and specs for the cylinder head and also i have enclosed the torque specs for the intake and its tightening sequence, good luck and hope this is helpful, have a good day. lbs. Install caps 3 and 5, gradually tighten untiil cam is drawn down fully and evenly in the bearing saddles.